need help
#1
need help
I have a 2002 f 350 and have done some work to it to make it run better. Before I started this project the truck ran real ruff. I had it scanned and the codes where 1209,1247,1211,and 0541. I ordered a new icp and ipr valve. I took the fuel bowl off, turbo and turbo pedistal. I also took the wiring harness off because there where several bare wires and it was covered in oil. i removed the ipc and did not get back to the truck for a few days. i noticed oil under the truck and realized the HPOP was draining thru the ipc opening. Made a mess in driveway but the hpop was drained so I put in the ipr and ipc. gutted turbo pedistal and replaced o-rings. Put everything back together and now The truck will not start. I have no idea what to do.I need some help.
#3
Does it try to start, or nothing at all. Just make sure to check connections on batts, I know when I have to lay all over the motor to work on my truck sometimes things can get loose.
---AutoMerged DoublePost---
also, how long did you try and start it and is the hpop full of oil.
---AutoMerged DoublePost---
also, how long did you try and start it and is the hpop full of oil.
Last edited by ju015dd; 08-23-2010 at 09:28 PM. Reason: Automerged Doublepost
#4
#5
Check the harness going to the valve covers they can become loose or unhooked witch wont fire the injectors. When i did all my work on my truck ( injectors, turbo, ped., meth, afe intake manifold) it would crank crank but not kick so my buddy sprayed some starter fluid in the intake and i kno thats a bad thing but we did it and it fired right up!
#6
#7
#8
#9
#10