#3 & #8 Balance Fault
#1
10-29-2012 | 08:00 PM
Thread Starter
|
Diesel Bomber
Joined: Jul 2010
Posts: 3,884
Likes: 144
From: Hays, KS
#3 & #8 Balance Fault
Well I finaly bought AE software. Any ways I plugged it in this evening and I have cylinder #3 & #8 balance fault when I run a contribution test. I ran a buzz test and all 8 buzz equally. Does this mean that those two injectors are not firing? I guess I'm asking where do I go from here?
Also, I did the test called KOER system test, and it raised the idle to about 1200 RPM and then is sounded like it took out one bank for about 30 seconds then picked back up and idled up to 1500 RPM and ran for about a minute and dropped back to a idle and said it passed. What did this test?
Also, I did the test called KOER system test, and it raised the idle to about 1200 RPM and then is sounded like it took out one bank for about 30 seconds then picked back up and idled up to 1500 RPM and ran for about a minute and dropped back to a idle and said it passed. What did this test?
