Ford Powerstroke 03-07 6.0L Discussion of 6.0 Liter Ford Powerstroke Turbo Diesels

Heat not blowing hot air after 10 min of idle

Thread Tools
 
Search this Thread
 
  #1  
Old 12-21-2012 | 08:31 AM
04 Stroke's Avatar
Thread Starter
|
Diesel Fan
Joined: Dec 2011
Posts: 44
Likes: 0
From: Cumberland, WI
Default Heat not blowing hot air after 10 min of idle

I have been noticing that if my truck idles for more than 8 min or so it starts blowing cool air. Once i step on the throttle it gets hot. Is that normal? Is something sticking? It has been about 20 degrees here and a little colder at night. Come out and expect a nice warm truck and its not that warm. The temp gauge shows it at running temp. Any ideas or suggestions would be great!
 
  #2  
Old 12-21-2012 | 08:46 AM
bobfbigman's Avatar
Diesel Bomber
Joined: Nov 2009
Posts: 1,942
Likes: 144
Default

Low on coolant, when you put coolant in always make sure the heat is on. Also check the little vacuum line that goes to the heat valve, it will be just behind the alternator on the 3/4 heater hose, the vacuum line gets knocked off all the time if you are putting your hand anywere near the turbo, the line will also be pretty close to the oil fill tube.
 
  #3  
Old 12-21-2012 | 09:10 AM
04 Stroke's Avatar
Thread Starter
|
Diesel Fan
Joined: Dec 2011
Posts: 44
Likes: 0
From: Cumberland, WI
Default

I will check both of those things!! thanks for the quick reply. What is the best kind of coolant to add?
 
  #4  
Old 12-21-2012 | 08:39 PM
bobfbigman's Avatar
Diesel Bomber
Joined: Nov 2009
Posts: 1,942
Likes: 144
Default

You don't want to mix coolants, it can create a gooy slime. If it is factory coolant then it should be Ford Gold.
 
  #5  
Old 12-27-2012 | 07:12 AM
Captainharley6.0's Avatar
Diesel Enthusiast
Joined: Oct 2010
Posts: 110
Likes: 2
From: PEI, Canada
Default

I am having the same problem, currently looking into head gasket issue, hope not the case, i am going to check my valve too thanks!


Sent from my iPhone using Tapatalk
 
  #6  
Old 12-28-2012 | 01:05 PM
04 Stroke's Avatar
Thread Starter
|
Diesel Fan
Joined: Dec 2011
Posts: 44
Likes: 0
From: Cumberland, WI
Default

I checked my valve and it was all good. I also added coolant and changed out my radiator cap since they are prone to failure. Next i was goin to try putting a piece of cardboard in front of radiator and see what happens. Let me know your findings as well.
 
  #7  
Old 12-28-2012 | 01:33 PM
Farmboy 2.0's Avatar
Diesel Bomber
Joined: Feb 2010
Posts: 2,386
Likes: 162
From: N. Idaho
Default

How cold is it where yall are at? These trucks require alot of coolant and and takes along time for that coolant to warm up.
 
  #8  
Old 12-28-2012 | 03:16 PM
04 Stroke's Avatar
Thread Starter
|
Diesel Fan
Joined: Dec 2011
Posts: 44
Likes: 0
From: Cumberland, WI
Default

it has been anywhere from 10 to 20 degrees for the last couple weeks. Its funny cause the temp gauge shows its at running temp
 
  #9  
Old 12-28-2012 | 04:29 PM
TheRobenator's Avatar
Diesel Enthusiast
Joined: Oct 2009
Posts: 110
Likes: 6
From: Georgia
Default

You know, a stuck open or busted thermostat will cause this also, that is a 10 minute check, might as well look into it.
 
  #10  
Old 12-28-2012 | 04:38 PM
Mdub707's Avatar
BOMBARDIER
Joined: Oct 2007
Posts: 8,208
Likes: 630
Default

Mine shows it's up to temp too, no heat until I drive it, but I also know there is no coolant in the bottle either, it's low and I'm not planning on adding any until the cab comes up soon.
 


Quick Reply: Heat not blowing hot air after 10 min of idle



All times are GMT -5. The time now is 09:17 AM.