Edge Comp And MAP Sensor....
#1
Edge Comp And MAP Sensor....
Hey guys, I know you can get more smoke with the MAP unplugged, and itll also set a P0237 code. However, is it safe to leave the MAP sensor unplugged as long as you want or will it do long term damage to engine/components.
---AutoMerged DoublePost---
anyone?
---AutoMerged DoublePost---
anyone?
Last edited by CumminsCrazed; 02-01-2008 at 08:50 AM. Reason: Automerged Doublepost
#2
#3
#5
Like Wyatt Earp sez, unplugging the MAP allows too much raw fuel which washes oil off the cylinder walls causing premature wear on the walls and piston rings.
The piston to cylinder wall clearance spec is a very close .0005" to .0015" and you have to protect those clearances with good operation & maintenance.
We're not talking about a loose built cheapo gasser motor.
The piston to cylinder wall clearance spec is a very close .0005" to .0015" and you have to protect those clearances with good operation & maintenance.
We're not talking about a loose built cheapo gasser motor.
#7
#9