how do you get the darn shift knob OFF????? Mine on my 04.5, the gear pattern is upside down and i was trying to get it turned around right so my GF can see the shift pattern without having to look upside down... i have tried turning it, but it seems pretty secured on there... is there a trick to getting it to move?????:humm::argh:

You shouldnt need to take the knob off.

Im not sure about the third gens but on the second gens - if you take a couple of very small screwdrivers and gently pry out the shit pattern (its just a cover), you can reposition it where it needs to be (also use some sort of glue so it doesnt move again).

There should be a nut under the shift pattern that holds the knob to the stick.

My 01 was like that,I took it loose down on the bottom,under the boot,and I put a washer in there to get to set right,might have to try a couple of different combos to get it line up right.
Not sure about yours,it might be different:pals:

if i had a cummins id get the red one

Ok i will try that.. Sorry guys i thought i had put this in the CR forum... I tried prying the cover off one time before, but i didnt want to ruin the knob so i quit.. I will have to try again.. THANKS:c::U:

I would think the third gens would be the same.

I really like this set of shift knobs, spendy? Yes. But they fit your hand great, and look better then the stockers.

Not sure if anyone answered the question about the revolver shift knobs. Here is a site ordered one from, got in in .44mag with empty chambers to carry spare ammo....*L*

.44 Magnum Billet Shift Knob - 44magbillet

Where can you get these shift knobs
​​​​​​

Shift knob ideas for free or cheap!
 

https://cimg6.ibsrv.net/gimg/www.die...bb3c37331.jpeg
Connecting rod shift handles, from the scrap pile out of a 6.9 international.