Won't rev past 2000
#1
Won't rev past 2000
I have an 02 Dodge 2500 and we just swaped out the auto for a manual. I fixed it so the cruse will work. I was wondering if there's anything else I need to do.. It has been running fine but after I fixed it it wont rev past 2000. I was wondering if theres another wire I needed to hook up.
---AutoMerged DoublePost---
I unhooked the battery cables and reconnected them, went and drove it then it came out of limp mode... I was wonder what kind of scanners do you use to look at codes.... my edge is too old to bring codes up on my attitude with juice. The swap made a huge difference.
---AutoMerged DoublePost---
I unhooked the battery cables and reconnected them, went and drove it then it came out of limp mode... I was wonder what kind of scanners do you use to look at codes.... my edge is too old to bring codes up on my attitude with juice. The swap made a huge difference.
Last edited by ifitaintsmokingitsbroken; 06-30-2012 at 08:59 PM. Reason: Automerged Doublepost
#5
#7
#8
You can send the ecm to bob wagner of mads electronics aka smarty power. He can bench flash the ecm for you. This is only needed on the 01-02 auto trucks after a manual swap. Or you can buy a smarty and bob can send you a manual recovery file if you dont want to be without the truck for a week.
Sent with a Droid RAZR in one hand and 14,000 volts in the other.
Sent with a Droid RAZR in one hand and 14,000 volts in the other.